zak designs
.

Product Care

melamine

melamine

  • dishwasher safe
  • do not microwave
  • dropping may cause breakage
zakwave

zakwave

  • microwave safe
  • oven safe to 350°
  • easy to clean, dishwasher safe
  • before use, wash thoroughly
  • do not use abrasive cleaners or pads, as they may scratch the glossy easy-clean finish
  • do not cook oils, butter, or fat substitutes without other foods
  • certain foods such as oatmeal, tomato based foods and acidic foods may cause fading. fading may occur with prolonged use
  • zakwave will be hot and hot grease or water can burn. use caution when removing from microwave
  • cooking times may vary depending on microwave strength and amount or type of food
  • soaking may cause fading
confetti and sprinkles

confetti and sprinkles

  • dishwasher safe
  • do not microwave
  • severe temperature changes could cause cracking
  • dropping may cause breakage
  • cupcake trays are not oven safe
tritan bottles with straws

tritan bottles with straws

  • dishwasher safe
  • do not microwave
  • spout must be completely open for liquid to come out
  • for best results, hand wash straws
moso bamboo

moso bamboo

  • consumers can dispose of moso at any waste facility that accepts compostable products
  • hand wash only
  • do not microwave
palouse bottles

palouse bottles

Hand Washing:

  • Unlock and lift all plastic pieces.
  • Using a straw brush or a pipe cleaner gently clean the crevasses of the lid.
  • Gently pull up on the silicone spout and clean underneath the rim and nozzle. (Be sure not to tear the silicone spout, it is not designed to be removed)
  • From the bottom gently pull down on the silicone straw holder and clean inside the straw hole with a straw brush or pipe cleaner.
  • Thoroughly rinse the lid and crevasses with warm water.
  • Before putting the silicone spout back in place on top and bottom, place the lid in a hot solution of bleach and water 1-2 times per week.
  • Let soak for 15 minutes
  • Remove from bleach solution and rinse thoroughly.
  • Let air dry before using again
slide lid tumblers

slide lid tumblers

To disassemble slide lids:

  • When lid is dry, turn the lid over so the bottom is facing up.
  • There are 2 tabs the hold the top slider on the lid gently push them towards each other till with you thumbs meanwhile pushing up at the same time.
  • Remove the slide from the lid.
  • Gently pull on the silicone seal that is on the outer rim of the lid.
  • Your lid should now be in 3 separate pieces (main lid piece, plastic slide, silicone seal)

Lid Cleaning Instructions:

  • Wash each piece with soap and water or in the dishwasher.
  • Soak each piece in hot water and bleach for 15 minutes.
  • Remove lid pieces from bleach solution and again wash with soap and water.
  • Rinse the pieces thoroughly and lay out to air dry completely before reassembling the lid.

Tumbler Cleaning Instructions:

  • Wash with warm, soapy water, scrubbing with a soft washcloth or sponge.
  • Do not use an abrasive pad, as this can scratch the finish of the tumbler.
  • Make sure to scrub all the way into the bottom corners of the tumbler. Use a dishwashing wand or bottle brush if necessary.
  • Dry completely before storing. Air drying is recommended; when drying by hand, ensure no water remains in the corners.
riverside bottles

riverside bottles

Cleaning Instructions

Dishwasher:

  • Push button to open spout.
  • Using a straw brush or a pipe cleaner gently clean the crevasses of the lid.
  • Gently pull up on the silicone spout and clean underneath the rim and nozzle.
  • Remove the silicone seal from the bottom of the lid.
  • Place lid on the top rack of the dishwasher with silicone spout slightly pulled away from the top and bottom. (Be sure not to tear the silicone spout, it is not designed to be removed)
  • Wash the silicone seal by hand.
  • Run through a normal or sanitizing cycle as desired.
  • Let air dry before using again.

Hand Washing:

  • Push button to open spout.
  • Using a straw brush or a pipe cleaner gently clean the crevasses of the lid.
  • Gently pull up in the silicone spout and clean underneath the rim and nozzle. (Be sure not to tear the silicone spout, it is not designed to be removed)
  • Remove the silicone seal from the bottom of the lid.
  • Thoroughly rinse the lid and crevasses with warm water.
  • Before putting the silicone spout back in place on top and bottom, place the lid in a hot solution of bleach and water 1-2 times per week.
  • Let soak for 15 minutes
  • Remove from bleach solution and rinse thoroughly.
  • Let air dry before using again