Product Care
Melamine
- dishwasher safe
- do not microwave
- dropping may cause breakage
Zakwave
- microwave safe
- oven safe to 350°
- easy to clean, dishwasher safe
- before use, wash thoroughly
- do not use abrasive cleaners or pads, as they may scratch the glossy easy-clean finish
- do not cook oils, butter, or fat substitutes without other foods
- certain foods such as oatmeal, tomato based foods and acidic foods may cause fading. fading may occur with prolonged use
- zakwave will be hot and hot grease or water can burn. use caution when removing from microwave
- cooking times may vary depending on microwave strength and amount or type of food
- soaking may cause fading
Confetti and Sprinkles
- dishwasher safe
- do not microwave
- severe temperature changes could cause cracking
- dropping may cause breakage
- cupcake trays are not oven safe
Tritan Bottles with Straws
- dishwasher safe
- do not microwave
- spout must be completely open for liquid to come out
- for best results, hand wash straws
Moso Bamboo
- consumers can dispose of moso at any waste facility that accepts compostable products
- hand wash only
- do not microwave
Palouse & Park Bottles
To Disassemble:
- Detach plastic straw from base of silicone spout
- Do not remove silicone spout, it is not designed for removal
- Unlock lid and push button to open spout
Using Dishwasher for Lid and Plastic Bottle:
- Place plastic bottle and lid in small parts container on top rack
- Run through normal or sanitizing cycle as desired
- Detachable straw should be hand washed with straw brush or pipe cleaner for best results
- Do not use with essential oils, as this can damage the straw
- Let air dry completely before using again
- Do not put stainless steel bottles in dishwasher – hand wash only
To Hand Wash:
- Use straw brush or pipe cleaner to thoroughly clean detachable plastic straw
- Do not use essential oils, as this can damage the straw
- Use straw brush or pipe cleaner to gently clean crevasses of lid
- Gently pull up on silicone spout to clean underneath rim and nozzle.
- Do not remove the silicone spout, it is not designed for removal
- Be careful and avoid tearing the silicone spout
- From underside of lid, use straw brush or pipe cleaner to clean inside straw hole
- Gently pull down on silicone straw holder and clean thoroughly with straw brush or pipe cleaner
- Thoroughly rinse lid and crevasses with warm water
- Use bleach mixture for a deeper cleaning 1-2 times per week
- Let soak for 15 minutes
- Remove from bleach solution and rinse thoroughly
- Hand wash bottle with soap and water
- Let air dry completely before using again
To Reassemble:
- Reattach straw into straw holder on underside of lid
- Close lid and screw back onto bottle
Contour Lid Tumblers
To Disassemble Lid:
- Gently separate silicone gasket from outer rim of lid
To Clean Lid:
- Wash lid and silicone gasket with soap and water, using water pressure to flush water behind slide portion of lid
- Place lid vertically in small parts container or top rack of the dishwasher
- For a deeper clean, soak lid and slider in hot water and bleach for 15 minutes
- Remove lid and slider from bleach solution and wash again with soap and water, using water pressure to flush water behind
- Rinse lid thoroughly
- Leave slider in open position unthreaded from body to air dry completely before using again
To Clean Tumbler:
- Wash with warm, soapy water, scrubbing with soft washcloth or sponge
- Do not use an abrasive pad, as this can scratch the finish of the tumbler
- Scrub down into bottom corners of tumbler, using dishwashing wand or bottle brush if necessary
- Dry completely before storing (air drying is recommended; when drying by hand, ensure no water remains in corners)
- For stubborn spots, gently clean with scrubbing sponge
To Reassemble Lid:
- Replace silicone gasket, flat side facing inward and grooved side facing outward
Slide Lid Tumblers
To Disassemble:
- Turn lid upside down on stable surface
- Using thumbs, press inward on two tabs to release slider
- Gently separate silicone gasket from outer rim of lid
To Clean Lid:
- Wash lid, slider and silicone gasket with soap and water or in small parts container in the dishwasher
- Soak lid and slider in hot water and bleach for 15 minutes
- Remove lid and slider from bleach solution and wash again with soap and water
- Rinse lid and slider thoroughly
- Let air dry completely before using again
To Clean Tumbler:
- Wash with warm, soapy water, scrubbing with soft washcloth or sponge
- Do not use an abrasive pad, as this can scratch the finish of the tumbler
- Scrub down into bottom corners of tumbler, using dishwashing wand or bottle brush if necessary
- Dry completely before storing (air drying is recommended; when drying by hand, ensure no water remains in corners)
- For stubborn spots, gently clean with scrubbing sponge
To Reassemble:
- Turn lid right-side up
- Align slider tabs with lid holes
- Using thumbs, press firmly to lock into place
- Replace silicone gasket, flat side facing inward and grooved side facing outward

